release notes | Book: 1.9.5, 1.9.12 (opt, FHS), 2.6 (FHS), 2.7 (FHS), 2.8 (FHS), 2.9 (FHS), 2.10 (FHS), 2.11 (FHS), | Wiki | Q&A black_bg
Web: Multi-page, Single page | PDF: A4-size, Letter-size | eBook: epub black_bg
Properties of the replica service
Prev Chapter 6. The replica Service (Replica Manager) Next
The dCache Book > Configuration of dCache > The replica Service (Replica Manager) > Properties of the replica service

Properties of the replica service

replica/cell.name

Default: replicaManager

Cell name of the replica service

replicaManager

Default: no

Set this value to yes if you want to use the replica service.

resilientGroupName

Default: ResilientPools

If you want to use another pool group for the resilient pools set this value to the name of the resilient pool group.

replicaManagerDatabaseHost

Default: localhost

Set this value to the name of host of the replica service database.

replicaDbName

Default: replicas

Name of the replica database table.

replicaDbUser

Default: srmdcache

Change if the replicas database was created with a user other than srmdcache.

replicaPasswordFile

Default: no password

replicaDbJdbcDriver

Default: org.postgresql.Driver

replica service was tested with PostgreSQL only.

replicaPoolWatchDogPeriod

Default: 600 (10 min)

Pools Watch Dog poll period. Poll the pools with this period to find if some pool went south without sending a notice (messages). Can not be too short because a pool can have a high load and not send pings for some time. Can not be less than pool ping period.

replicaExcludedFilesExpirationTimeout

Default: 43200 (12 hours)

replicaDelayDBStartTimeout

Default: 1200 (20 min)

On first start it might take some time for the pools to get connected. If replication started right away, it would lead to massive replications when not all pools were connected yet. Therefore the database init thread sleeps some time to give a chance to the pools to get connected.

replicaAdjustStartTimeout

Default: 1200 (20 min)

Normally Adjuster waits for database init thread to finish. If by some abnormal reason it cannot find a database thread then it will sleep for this delay.

replicaWaitReplicateTimeout

Default: 43200 (12 hours)

Timeout for pool-to-pool replica copy transfer.

replicaWaitReduceTimeout

Default: 43200 (12 hours)

Timeout to delete replica from the pool.

replicaDebug

Default: false

Disable / enable debug messages in the log file.

replicaMaxWorkers

Default: 6

Number of worker threads to do the replication. The same number of worker threads is used for reduction. Must be more for larger systems but avoid situation when requests get queued in the pool.

replicaMin

Default: 2

Minimum number of replicas in pools which are online or offline.

replicaMax

Default: 3

Maximum number of replicas in pools which are online or offline.

replicaCheckPoolHost

Default: true

Checks tag.hostname which can be specified in the layout file for each pool.

Set this property to false if you do not want to perform this check.

replicaEnableSameHostReplica

Default: false

If set to true you allow files to be copied to a pool, which has the same tag.hostname as the source pool.

Note

The property replicaCheckPoolHost needs to be set to true if replicaEnableSameHostReplica is set to false.

Prev Up Next
Operation Home Chapter 7. The poolmanager Service