- Naming and addressing
The dCache system is divided into cells which communicate with each other via messages. Cells run inside domains and cells communicate by passing messages to each other. Domains are connected through cell tunnels which exchange messages over TCP.
Each domain runs in a separate Java virtual machine and each cell is run as a separate thread therein. Domain names have to be unique. The domains communicate with each other via
TCP using connections that are established at start-up. The topology is controlled by the location manager service. When configured, all domains connect with a core domain, which routes all messages to the appropriate domains. This forms a star topology.
ONLY FOR MESSAGE COMMUNICATION
TCPcommunication controlled by the location manager service is for the short control messages sent between cells. Any transfer of the data stored within dCache does not use these connections; instead, dedicated
TCPconnections are established as needed.
Within this framework, cells send messages to other cells addressing them in the form cellName@domainName. This way, cells can communicate without knowledge about the host they run on. Some cells are well known, i.e. they can be addressed just by their name without @domainName. Evidently, this can only work properly if the name of the cell is unique throughout the whole system. If two well known cells with the same name are present, the system will behave in an undefined way. Therefore it is wise to take care when starting, naming, or renaming the well known cells. In particular this is true for pools, which are well known cells.
A domain is started with a shell script bin/dcache start domainName. The routing manager and location manager cells are started in each domain and are part of the underlying cell package structure. Each domain will contain at least one cell in addition to them.
Domains must have a name unique through the dCache installation. Each cell has a unique name within the domain in which it is running. A fully qualified cell address is formed by combining the cell name and the domain name with an at-sign, e.g.
PoolManager@dCacheDomain. Unqualified addresses either do not have a domain suffix or have a
local suffix, e.g.
PoolManager@local. It follows that
local is an illegal domain name.
Each domain has a message routing table. This routing table may be inspected and manipulated through the
System cell inside that domain. Routing tables are maintained automatically by dCache and there is usually no need to manipulate these manually.
There are several different types of routes:
|Routes to other domains
|Used for publish-subscribe messaging
|Used for named queues
|A rewriting rule
|Default route if no other route matches
There are a few other route types which are not commonly used.
Tunnels are cells that establish TCP connections to other tunnels. A tunnel may either be listening or connecting. When a connection is established each end adds a domain route to the local routing table allowing messages to the other domain to be routed through this tunnel. When the tunnel cell shuts down the domain route is removed.
dCache domains are designated as either
core domains or
satellite domains in the configuration. Core domains act as message hubs, forwarding messages on behalf of satellite domains.
Core domains form a fully connected mesh, that is, each core domain has a tunnel cell connecting it to a tunnel cell in another core domain. Lexicographic ordering of the domain name is used to determine which domain connects and which domain listens for a connection.
Satellite domains connect to all core domains.
Other than that, there are no differences between core and satellite domains - they can both host arbitrary dCache services, including none at all.
The location manager is an implicit service embedded in every dCache domain. The cell is called
lm and one can interact with each instance through the dCache admin shell. Its task is to establish cell tunnels.
On core domains it will start a cell listening for incoming connections (by default on TCP 11111 - remember to firewall access to this port). Each core domain registers itself in Zookeeper.
On satellite domains the location manager watches the ZooKeeper state and whenever a core domain registers itself, all satellites will create tunnel cells connecting to the core.
Each domain has an embedded routing manager service. The cell is called
RoutingMgr and one can interact with each instance through the dCache admin shell. Its task is to manage the routing table.
The routing manager monitors the addition and removal of tunnel cells and domain routes. Whenever a domain route is added in a satellite domain, the routing manager adds a corresponding default route. Similarly, whenever a tunnel cell dies, it will remove the installed routes going through that tunnel.
Routing manager instances exchange messages with each other to maintain topic and queue routes.
The concept of named queues is borrowed from other messaging systems, even though as we will see in a moment the name is slightly misleading in dCache.
A named queue has an unqualified cell address. Cells writing to a named queue are called producers while cells reading from a named queue are called consumers. A named queue can have multiple producers and multiple consumers, but each message is only consumed by a single cell.
Producers do not need to do anything special to write a message to a named queue. Consumers however explicitly have to announce that they want to consume from a queue. When they do this a queue route is installed in the local routing table, allowing messages sent to that queue to be routed to the consumer. The routing manager picks up the new route and forwards this information to other routing managers. In particular a consumer in a satellite domain will cause a corresponding queue route to be installed in all core domains. A consumer in a core domain too will cause queue routes to be installed in satellite domains. Consumers in satellite domains do not, however, have queue routes in other satellite domains - messages instead follow a default route to a core domain which will know where to route the message.
When several queue routes apply, one is chosen randomly. In this way a certain amount of load balancing is achieved. Note that no effort is made to perfectly balance the load. Also note that the address space of a named queue and cells is not separate. A cell with the same name as a named queue is legal and if a local cell matches, the message is always delivered locally - i.e. local delivery takes precedence over the routing table.
Many services in dCache consume messages from a named queue that is the same as their cell name. This way other services do not need to know the fully qualified address of the service and can merely write messages to the named queue.
As may have been apparent from the description above, a named queue is not actually a queue. There is no central store of messages and there is no central queue in a named queue. The latency involved in communication does introduce a buffer capacity allowing a certain number of messages in transit between sender and receiver, but this does not constitute a shared queue. A message produced is routed to a consumer and queued locally at the consumer.
The concept of topics is also borrowed from other messaging systems. A topic is an unqualified cell address. Cells writing to topic are called publishers, while cells receiving messages on a topic are called subscribers. In contrast to a named queue, messages published to a topic are received by all subscribers. Thus topics provide a multicasting ability to cells.
As with named queues, publishers do not need to do anything special before writing a message to a topic. Subscribers need to explicitly announce that they want to subscribe to a topic. When they do, a topic route is added to the local routing table. The routing manager picks up the new route and informs other routing managers about the subscription. In particular routing managers in cores contain topic routes to subscribers in other satellite domains and other core domains. Satellite domains however only contain topic routes to local subscribers. Subscribers in other domains are informed through the default route.
This difference in routing logic with respect to queue routes stems from the fact that a message to a topic is delivered along all topic routes - as well as one of the default routes. Messages to named queues on the other hand are only routed along one of the queue routes chosen at random.
All domains default to being satellite domains. Unless some domain is explicitly marked as a core domain, domains will be disconnected from each other.
In a mulit-domain (and multi node) deployments at least one of the domains must be configured as
One may alter the default behavior by setting
dcache.broker.scheme to either
satellite to designate the domain as either a core or satellite domain.
A simple star topology obviously makes the central message hub a single point of failure. Since dCache 2.16 it is perfectly valid to have multiple core domains. As mentioned above, the core domains form a fully connected mesh. Satellite domains connect to all core domains such that the distance between two satellite domains is never longer than two hops (i.e. a maximum of one intermediate domain).
The configuration of such a setup follows the same approach as above: Each core domain sets
core. Core domains register themselves in ZooKeeper and other domains locate them that way.
Care is taken to cleanly register and unregister core domains in a multipath setup to minimize the effect on the running system. Obviously any service that happened to be running in a core domain being shut down will be unavailable and any task that service may have been working on may be lost. Other services will eventually discover such a situation through a timeout.
Without having production experience with such a setup yet (dCache 2.16 has not (yet) been released when this is being written), our recommendation would be to have two or three core domains.
For small installations it is viable to mark all domains as cores. In such a setup all domains are connected to all other domains. This doesn’t scale, but if you don’t have more than, say, 10 domains, this should work out just fine. The benefit is that the distance between services is reduced, resulting in lower latency.
A word of warning though: The cells messaging system is deliberately very simple. There is no guaranteed delivery and no guaranteed ordering. Although dCache should be robust against such problems, core only deployments will be in uncharted territory.