release notes
| Book:
1.9.5,
1.9.12 (opt, FHS),
2.11 (FHS),
2.12 (FHS),
2.13 (FHS),
2.14 (FHS),
| Wiki
| Q&A
In the 1.9.4 series, stage protection had to be configured in every door and in the PinManager.
Starting with the 1.9.5 series, stage protection can optionally be configured in the PoolManager
rather than on the doors and PinManager. Thus the white list needs to be present
on a single node only. To enable this, define the following parameter in config/dCacheSetup:
stagePolicyEnforcementPoint=PoolManager
The file name of the white list must be configured by setting the
stageConfigurationFilePath parameter in config/dCacheSetup:
stageConfigurationFilePath=${ourHomeDir}/config/StageConfiguration.conf
The parameter only needs to be defined on the nodes which enforce the stage protection;
i.e., either on the doors and PinManager, or in PoolManager.