release notes | Book: 1.9.5, 1.9.12 (opt, FHS), 2.7 (FHS), 2.8 (FHS), 2.9 (FHS), 2.10 (FHS), 2.11 (FHS), 2.12 (FHS), 2.13 (FHS), | Wiki | Q&A black_bg
Web: Multi-page, Single page | PDF: A4-size, Letter-size | eBook: epub black_bg
Setting up
Prev Chapter 11. dCache as xRootd-Server Next
The dCache Book > Configuration of dCache > dCache as xRootd-Server > Setting up

Setting up

To allow file transfers in and out of dCache using xrootd, a new xrootd door must be started. This door acts then as the entry point to all xrootd requests. Compared to the native xrootd server-implementation (produced by SLAC), the xrootd door corresponds to the redirector node.

To enable the xrootd door, you have to change the layout file corresponding to your dCache-instance. Enable the xrootd-service within the domain that you want to run it by adding the following line 

..
[<domainName>/xrootd]
..

Example:

You can just add the following lines to the layout file: 

..
[xrootd-${host.name}Domain]
[xrootd-${host.name}Domain/xrootd]
..

After a restart of the domain running the xrootd door, done e.g. by executing 

[root] # ${dCacheHome}/bin/dcache restart xrootd-babelfishDomain
Stopping xrootd-babelfishDomain (pid=30246) 0 1 2 3 4 5 6 7 done
Starting xrootd-babelfishDomain done

the xrootd door should be running. A few minutes later it should appear at the web monitoring interface under "Cell Services" (see the section called “The Web Interface for Monitoring dCache”).

[return to top]

Parameters

The default port the xrootd door is listening on is 1094. This can be changed two ways:

  1. Per door: Edit your instance’s layout file, for example /etc/dcache/layouts/example.conf and add the desired port for the xrootd door in a separate line (a restart of the domain(s) running the xrootd door is required): 

    ..
[xrootd-${host.name}Domain]
[xrootd-${host.name}Domain/xrootd]
    port = 1095
..

  2. Globally: Edit /etc/dcache/dcache.conf and add the variable xrootd.net.port with the desired value (a restart of the domain(s) running the xrootd door is required): 

    ..
xrootd.net.port=1095
..

For controlling the TCP-portrange within which xrootd-movers will start listening in the <pool>Domain, you can add the properties dcache.net.lan.port.min and dcache.net.lan.port.max to /etc/dcache/dcache.conf and adapt them according to your preferences. The default values can be viewed in /usr/share/dcache/defaults/dcache.properties. 

..
dcache.net.lan.port.min=30100
dcache.net.lan.port.max=30200
..
Prev Up Next
Chapter 11. dCache as xRootd-Server Home Quick tests