release notes
| Book:
1.9.5,
1.9.12 (opt, FHS),
2.11 (FHS),
2.12 (FHS),
2.13 (FHS),
2.14 (FHS),
| Wiki
| Q&A
The following list describes which parameters may be used in conjunction with dCache partitioning. The ’Old command set’ is still valid for the default parameter section, while new command set has to used to manipulate non-default sections.
Table 10.1. New and old PoolManager parameter names
| Old Command | New Command | Parameter Type |
|---|---|---|
| set pool decision -spacecostfactor=<value> | pm set [<section>] -spacecostfactor=<value> | float |
| set pool decision -cpucostfactor=<value> | pm set [<section>] -cpucostfactor=<value> | float |
| set costcuts -idle=<value> | pm set [<section>] -idle=<value> | float |
| set costcuts -p2p=<value> | pm set [<section>] -p2p=<value> | float |
| set costcuts -alert=<value> | pm set [<section>] -alert=<value> | float |
| set costcuts -halt=<value> | pm set [<section>] -halt=<value> | float |
| set costcuts -fallback=<value> | pm set [<section>] -fallback=<value> | float |
| rc set slope <value> | pm set [<section>] -slope=<value> | float |
| rc set p2p on|off | pm set [<section>] -p2p-allowed | boolean |
| rc set p2p oncost | pm set [<section>] -p2p-oncost | boolean |
| rc set p2p fortransfer|notfortransfer | pm set [<section>] -p2p-fortransfer | boolean |
| rc set stage on|off | pm set [<section>] -stage-allowed | boolean |
| rc set stage oncost | pm set [<section>] -stage-oncost | boolean |
| rc set max copies <copies> | pm set [<section>] -max-pnfs-copies=<copies> | integer |